Hi all, I have a TS-230 running QTS 5.2.9.3499 with two Seagate Ironwolf 4TB disks (ST4000VN008-2DR166) in a RAID 1 setup. Happily running but S.M.A.R.T now gives me a message that one of the disks is experiencing bad blocks and advises to switch the disk. Bought a new (exactly the same type) sealed…

Can you try a full set of tests of the disks on your other machine? It could be busted afterall [圖片] I'm running into errors when trying to upgrade my drives Storage Yes, that is not the problem then. The fact that the NAS is apparently putting multiple partit…

Please power off the device, insert the new drive along with the drives that are not faulty, and try again. If the rebuild still fails, please take a screenshot of the error message and share it with us, or open a support ticket so our Support Team can assist you.

It seems that there is a disk hardware failure that is the root cause of this problem. diskpart is not able to create a partition either if I connect the drive to a SATA connector, even though I can see the full uninitialized disk connected and correctly listed and selected. Might have to get the di…

Thanks SteveKo for chipping in. Appreciate your efforts in helping out. As stated in response to dolbyman’s friendly advice, I think the drive is dead and not writable. Now in contact with the seller to reach a swap agreement.

TS-230 無法在新硬碟上建立磁碟分割區

English 儲存空間

dolbyman 2026年08月08日14:20 2

你能在你的另一台機器上完整測試這些硬碟嗎？畢竟它可能真的壞了