MacOS: ventura 13.7.8 TS-262 Serial Number QW5LU11906T Firmware Version: 5.2.9 BUILD 20260514 Network Setup: Single port ( I’m assuming - I know no different) Single Seagate 4 TB drive I read where certain newer models of the TS-262 one could add more memory. I have 4 gig and would like to…

Open up your NAS and see if your RAM is soldered or socketed. There should be a few discussions about what RAM models would be compatible(google), to be on the safe side, you can always buy the RAM at a place with a good return policy (and make sure to keep the old RAM)

@dolbyman , thanks for quick reply. Yeah, I opened covering and I don’t see any soldering. I see i think some clips on side i’ll figure out how to pop open. Here is a picture. I did google and that is where i found the recommended memory being DDR4 either 2666 or 3200 mhz… [IMG_4895]

I meant specific memory modules (that can be very tricky)

[画像] Stimple: DDR4 either 2666 or 3200 mhz Hello, i think you can use both For my TS-264 i use this [画像] Ts-264 specifications English Hello, my TS-264 work fine with 40 GB RAM and 2 NMVE-SSD (WD SN700). [image] [image]

TS-262 メモリーアップグレード

English 互換性

Becker2020 2026 年 9 月 23 日午後 3:43 5

こんにちは。

どちらも使えると思います。
TS-264ではこちらを使っています。