I have a relatively new TVS-h674 running QuTS hero h6.0.1.3550 i512400 32GB 6x 20TB ST22000NT001-3LS101 2x 4TB SSD 9100 PRO with Heatsink 4TB That gives me ~77.69TB using RAID 6 This is a home + 2x home office NAS with all our precious photos, backups of individual PCs, laptops, etc. The TVS-h67…

Your pool threshold (top level) is triggered, disable or change the threshold No need to censor internal IPs Make sure you know how cache can rain on your parade, best to get rid of it.

@dolbyman Thanks for your reply. I get this warning: [Disable_Low_Space_Warning] I do want to be warned when the entire NAS is nearly full, say 95% Manually adding up the shared folders, I only have ~52 TB used of the 74 TB, so I should be at only ~70% full. Yet I am still getting a warning.

The thin volumes seem to also have snapshots enabled, I hope none are overprovisioned. Maybe you should switch to thick or just divide your storage via subfolders and not that many different provisioned folders (volume equivalent on QuTS) P.S. as the cache warning was ignored, another warning abou…

[gambar] Baxsie: so I should be at only ~70% full I think you have a problem with some folders [image] There are more data on your folders. Can you post a picture from a folder

@dolbyman , @Becker2020 : Thank you for looking at this and your replies. I think you have a problem with some folders [image] There are more data on your folders. [gambar] Becker2020: Can you post a picture from a folder I used windows explorer to do “properties” on the content of each f…

If you disable snapshot guaranteed space, that space should be reclaimed. Just resetup your whole NAS and setup your system pool on SSD Here is a recent example how QuTS cache can be detrimental [gambar] Disk performance extremely slow after raid 5 disk failure rebuild Sto…

@dolbyman Thank you for your reply and advice. You have convinced me on the SSD cache :skull_and_crossbones: :skull: :skull_and_crossbones: [gambar] dolbyman: Just resetup your whole NAS and setup your system pool on SSD OK. So, since I have just set up my old TVS-471 with 4x 24GB drives, I…

[gambar] Baxsie: Is there a guide or tutorial I know only this How do I set up my NAS? | QNAP My way: Started the nas only with the 2 NMVE-SSD creating a Pool mit some volume (qts) or folders (QuTShero) Install the apps in the systempool (QuTShero) or the systemvolume (QTS) Then install t…

[gambar] Baxsie: I used windows explorer to do “properties” on the content of each folder. That not the picture i want. Post a picture from the folder in QuTsHero like that [image]

Based on the picture you first showed, you are over subscribed on your drive space (103.5 TB on your volumes vs. 77.6 TB physical). You volumes take up more space than you physically have. Now, that’s not necessarily a bad thing. I am way over subscribed on both of my NAS units. That said, you n…

Peringatan (Batas tercapai): butuh bantuan mengatur storage pool TVS-h674

Inggris Penyimpanan

Becker2020 Agustus 5, 2026, 3:43pm 18

Saya harap kamu bisa beralih dari QuTshero 6.0 ke QTS 5.2